Office (719) 362-0258

We're

Totally in Control

News

We are busy as you can see with the projects shown below!

Top Stories

 

  • IntelliVerter in Production - Now Available
    Product in production
    A control to manage the inverter in a Recreational Vehicle allowing for automatic cycling of the inverter, which will extend the time required between battery charges.

 

  • BattStat in Design Phase - Now Available
    Product in production
    A control to monitor and report the status of house batteries in an RV.

 

  • HC-05 Programmer - Now Available
    Product available
    A standalone batch programmer for programming AT mode on HC-05 bluetooth modules

 

  • TinyDuino shields - Many Available
    Various product's in production
    We are designing and building a series of shields that can be used with the cutest (shouldn't say that IT WORKS!!) micro-controller on the market. These shields allow development for those of us using through hole technology. It increases the footprint size a little but adds some functionality.

 

  • TinyDuino OLED/433mHZ RF Link Receiver/Prototype Shield Now Available
    Product available
    A prototype shield for the TinyDuino providing availability to all pins. The board also contains a I2C OLED port connected to A4 & A5 pins; A 433mHz RF Link Receiver port connected to pin 9.

 

  • TinyDuino_Proto_1.00 Now Available
    Product available
    A prototype shield for the TinyDuino providing availability to all pins and still allowing space for your development using through hole technology and .100 spacing.

 

  • TinyDuino OLED w Bluetooth 1.00 - Now Available
    Product available
    A board prepared with a I2C OLED port connected to A4 & A5 pins; A Bluetooth port connected to pins 0 & 1. The prototype area onboard for the TinyDuino provides availability to all pins. Limited by space required for the attached components.

 

  • ProMini Stack System Base_1.00 - Now Available
    Product available
    A board prepared for the mounting of a Pro-Mini processor with pins tied to the shield system manufactured by Control House. All the shields shown on this site for the TinyDuino can be attached to this processor base unit.

 

  • Honda EU3000is Generator Mount
    Now Available
    Mount your Honda EU3000is on your RV rear bumper. This mount fits the generator like a glove! It fastens to your 4" square tube bumper using clamps. You are still able to lock the generator down to the mount and use the factory cover for protection while you travel.

 

  • Honda EU3000is Bluetooth Remote Start
    In Development
    Start and stop your generator from inside your camper! No need to add additional remotes. This one works with your Android device. It controls the choke and everything! It even allows control of the economy mode of the generator.

 

  • IntelliVerter Momentary Contact Module
    In Development
    Module allows IntelliVerter to control inverters requiring a momentary contact closure. The module ties into the inverter using RJ11 port and connects to the IntelliVerter using the INV terminals.

 

  • BT Inverter Remote
    In Development
    Got an inverter you want to control from a remote location? Don't want to route wires or cables? Want to avoide making holes in your car, truck, RV, or Boat? There is a solution...go wireless Bluetooth to your Android and control your inverter. The control unit mounts near the batteries, tie in two power leads, plug the RJ-11 jack from your inverter to the control box. No cutting holes, just drill a couple holes for the control unit. The control unit will report back to your cell phone showing the inverter status. You will be able to turn the unit off and on. It will even readout your battery voltage. The control works with inverters that require a dry contact to operate.